Probably not much selling point leverage but what the heck. This Borla rear section was pictured in GMHTP while on Charles Washington's 10 second convertible SS.

I have had on my car now for a couple years. It is still in good condition.

I would like $175. And would like to meet someone to sell. It would be a pain to ship.

where are you located? and by rear section, you mean everything after the axle?

Lonnie's in western Michigan. That might be a drive for you if you're in Atlanta as your sig says.

Like Mike said I am in SW MI.

Atlanta 'may' be doeabe though. I was planning on going to Atlanta for the Pro Solo. I am not sure now since I am having problems with my car.

I have alot to do with only a month or so to do it.

I would be able to let you know about meeting in Atlanta in a week or two.

I also plan to be at the F-body event in Indy this year.

Oops. I almost forgot.

Yes the rear section is a short section over the axle, The muffler, and drivers side and passengers side tips. I also have only two plates. One with a small hole (1" or so) and one wide open.

you know what size it is? 3" if you are coming to atlanta and don't mind driving with it, i'll take provided its not rusted out or anything when would you be in the atlanta area? the 4 year old flowmaster/stock tips are starting to look a little worn.. and this is the dual/dual tips right? thanks in advance

Turns out I won't be in Atlanta. I have some problems with the car and don't think I will be able to get everything done in time.

FWIW it's not rusted out. And never will be. It's Full stainless construction. And yes it is a dual/dual tip setup.

I have to try and sell locally. But if not I will check on shipping to you. I know it is shippable. That is how I got it. But it will be a nightmare to package.

thanks, just try and sell it locally then, i know it will probably be a bit to ship since it is oversized and all i'm sure.