Rollbar is sold

I also have a protoype carbon fibre hood. It came installed and painted on the car, and attaches with 4 hood pins (included). It is not show car quality, there are a couple of blisters on the surface, and a couple of the reinforcing ribs have been trimmed for underhood clearence. $200 + shipping

http://i1137.photobucket.com/albums/n506/9...e1/P1000673.jpg
http://i1137.photobucket.com/albums/n506/9...e1/P1000668.jpg
http://i1137.photobucket.com/albums/n506/9...e1/P1000666.jpg
http://i1137.photobucket.com/albums/n506/9...e1/P1000665.jpg

Any photos of the Roll Bar?

Here is the pic at Wolfe, http://www.wolferacecraft.com/detail.aspx?ID=246
I'll mock it up on weds and take a pic of it, I just have to find a good hosting site. For those considering it, I'll pay any shipping over the $175 that Wolfe charges, that is to the continental USA

Any pics of the hood and it's defects? what years of f-body does it fit?

Yes I will put pics them up this eve, it's a '98-'02 Camaro (non-SS style)

OK I set up a photobucket account, and put up rollbar and hood pics. I was describing the hood by memory in the earlier post, turns out it wasn't blistered. What I was referring to was the reinforcing ribs on the underside seemed to trap gas or similar during it's manufacturer, and it caused the hood to bulge a little above the ribs. The hood is painted hugger orange and you can see the cloth pattern underneath the paint. I also weighed the hood, and i came in at a hefty 8 lbs

http://s1137.photobucket.com/albums/n506/96Mike1/Low%20res/