I have a '89 Camaro and just finished painting it and while I'm putting it back togather figure I'll tighten the seal on the t-tops. Does anyone know if you can adjust them down any so they have a better seal. I have one thats leaking along the rear edge and if I can save from buying a new seal, old one looks good, it be the way to go for now.

I know on 2nd gens you could do it some, is it the same for 3rd gens? Thanks for any advice.

Once you pull the trim, you should see two screws that hold the t top retainer "sockets". You can adjust them within the range of the slots.

Thanks TrackBird,

Found them and adjusted them some, once I can get it out the garage tomorrow, will hit the car with the hose and check it out.