17x11 ZR1 style wheels with Hoosier 315's

I have a set of 4 AFS 17x11 ZR1 rims with hoosier A6 315's on them they are 50mm rear offset and 34mm front offset , no spacers needed, they are the polished finish
I am asking 500 + shipping for them , shipping will be pricy, I am located in Mass so local sale would be better

used race tires for sale

I have some used race tires that I wont be using. They were bought as scrubs from roadrace teams with minimal time on them Most with only 3-5 heatcycles. I was trying to figure out what worked best on my corvette.

First

set of 4 Kumho V710 size 285/30/18 I paid 450 + shipping asking 400. I never even mounted these up as they turned out to be too small for my rims. The were sold to me as 3 heatcycle scrubs.



second

I have a pair of Hoosier A6 size 275/30/18 I got these as 4 heatcycle tires and I ran the last autocross event with them on the front( way too small) asking 150 for the pair





third

I have a pair of Hoosier A6 size 335/30/17 These came on a set of wheels I bought and they have decent rubber but an 09 date on them asking 100 for the pair



Fourth

I have a set of 4 Yokohama roadraceing slicks they are 18in, and was told they are Porshe Cup tires, they 2 front are 230 width and the rears are 280, they have tons of rubber on them. asking 200 for all 4



All tires are sold with the buyer paying all shipping costs, and shipping tires can get costly

17x11 ZR1 rims polished

I have a set of 4 17x11 ZR1 rims. These are the correct offset to use on an F-Body with no spacers (50mm rear GS offset and 36mm front C4 offset) They are AFS rims and have been my autox rims, so very low miles(less than 200 total) no curb rash or anything, just need a polish and ready to go. I am selling the camaro for a C5 Z06 and these wont fit.
anyone interested let me know
I am asking 800 or BO + shipping cost

1999 Camaro SS, Lots of mods, low miles

1999 CAMARO SS
26k miles
Second place in car craft Real Street Eliminator comp
this years NER SCCA CP championship winning car
in show car condition.
I have all pics and documents to trace this cars life since it was special ordered by me
asking 15,500 as it is currently set up
I also have many of the original parts avail ( seats, wheels and tires, exh etc)


1999 CAMARO SS



SLP Build Number 1438


Factory Options:

SS package
6-speed Manual
Power Accessory Group
Rear Window Defogger
Monsoon Radio
12 Disk CD Player

SLP Y2Y options:

Dual-Dual performance Exhaust ( removed)
Camaro SS floormats
Castrol Lube Package
Key fob/Dash Plaque

Additional Modifications:
PRC stage II ported LS6 heads, milled
Custom Lunati cam 224/224/ 115.5 .558 lift
PRC Valve Springs
Hardened Pushrods
Kooks Longtube Headers
High Flow Cats
Custom True Dual exh by Kooks with SLP tips
FAST 92mm Intake Manifold
Custom PCM Dyno Tuning ( By Slowhawk)
Ramchargers Timing tuner
Nitrous express wet N2O plate (75-150hp)
Custom hard line pumbing from plate to noids
Purge
Pressure controlled Bottle heater
N2O pressure guage
Racetronics Intank fuel pump with Hot wire kit
Corvette Zo6 brakes, conversion kit by LG Motorsports
Hawk HP+ Brake Pads
Braided Stainless Steel Brake Lines
Koni double adj shocks
Strano 35mm hollow Front Swaybar
93 GM 1LE 21mm Rear Swaybar
Global West Subframe Connectors
Global West Front Upper Control arms
BMR Rear Lower Control Arms (adj poly/ rod end)
Coil-over front conversion 550lb springs
Strano Rear Springs
LG Motorsports Driveshaft Loop
GM C4 Corvette Rims ( 17x 9.5, 17x11)
UMI adj Panhard Rod ( 2x rod end)
SLP Strut Tower Brace
GM 1LE Tranny Mount
McLeod Kevlar Single Disk Clutch
McLeod Billet Adjustable Clutch Master Cylinder
Midwest Fab 9IN ford rearend
3.70 gears
Detroit Tru-track diff
Forged Axles 33 spline
ARP Hardened Lug Studs
Tubular torque arm with separate off tranny front mount
SLPAir Cleaner Lid
Pro 5.0 Shifter
Hurst Line Lock
Autometer Shift Light
Autometer Fuel Pressure Guage
Autometer Air/Fuel Guage
LG Motorsports Harness Bar
5-Point Racing Harness


Factory parts that I have avail for sale

17x9 grey SS rims with original tire( less than 500 miles)
Factory cloth seats( dr side power)
SLP exhaust ( desirable Dual/Dual)
Factory SS springs and shocks ( same springs as 1LE package)
Factory 32mm front swaybar
Factory 10-bolt rearend with 3.42 gears and torsen( approx 1k miles)
Factory rear control arms

Avail for sale also
Set of 4 17x11 Zr1 replica wheels polished( correct offset for both front and rear) With Hoosier A6 tires 315/35/17 mounted

FS: stuff for sale, 12 bolt, LCA, PHB, 315 kumhos, etc

I would like to sell the seats local As the shipping would be costly

Panhard rod fixed length poly bushings new 75.00

LG panhard rod fixed length poly bush, one end needs steel sleave used 50.00

Old Spohn LCA's dual rod end, need new rod ends 50.00

32MM Front swaybar fron the 1LE/ SS package 50.00

A set of Firebird cloth seats in grey, power driver seat inc rear seats 300.00

Nitto Drag radials 275/50/15, 3/4 tread left, one had patch from a small nail 75.00 for the pair

pair of LS1 heads, Bought from Lingerfelter as takeoffs, looks like they were reject portings , I got screwed. selling for 75.00 if someone want a set to pratice porting on, PS scrap alum price on these is 50.00 if you want to play at being a porter.

I just borrowed a camera, So I can email pics to those who are interested, just pm me a address.