(IMG:http://i180.photobucket.com/albums/x210/v7guy/P1300061.jpg)

BMR dbl adjustable steel panhard bar. Poly ends still fine. The finish is a little beat up but some rattle can will clean it right up. Had it on my car for a couple years and switched to a rod ended aluminum bar. $60 + shipping

(IMG:http://i180.photobucket.com/albums/x210/v7guy/P1300062.jpg)

DMS lowering springs for the rear I do not have the fronts The finish is beat up but they are fine otherwise and did the job well. the typical 1 1/2 - 1 3/4 inch drop but with a slightly stiffer spring rate as I recall. They rode nicely and looked good, I replaced them with a coilover setup. $50 + shipping

I also have an some stock LT1 valve covers with seals/oil cap, a rear cloth graphite seat, alternator stabilizer bar, an AC compressor of unknown condition and a few other items that I'll add later. If you want any of these make me an offer. They're just cluttering the garage.